DeLorean Industries Front Frame Harness Fans/Horn/Fuel Pump/Sender (New Production) Designed as a total solution to replace factory failure-prone and aged components.
Features/Differentiation, What's in the Box?, Component History & Engineering Solutions, Specifications, & Current Installation Instructions
Features and how does this component differentiate from the rest?
_ Designed, engineered, manufactured, and tested in-house, resulting in total product control.
_ Manufactured from TXL Cross-Link wire. Constructed from bare copper stranded wire that exceeds SAE J1128, Ford M1L-123A, and many additional industry requirements. The exterior features chemically cross-linked polyethylene insulation ( XLPE), resulting in superior heat and flame resistance and operational cycle characteristics. Extreme resistance is exhibited against oil, gasoline, acids, solvents, and moisture.
_ Service-ready quick-disconnect Delphi Weatherpack connectors were implemented on fans and fuel pump components, maintaining a factory connect capacity to the main harness junction.
_ Quick disconnect flying lead to filler neck ground point. Allows for removing harness/servicing pump area without pulling the upper closing plate to disconnect the ground wire from the filler neck.
_ Built in sealed capacitors integrated into fan circuit harness sections.
_ Quick disconnect flying leads on cooling fans, allowing for integration directly to either Phase 1/ Phase 2 DeLorean Industries Upgraded Fan Systems, Factory, or Aftermarket with sealed connectors.
_ Replacement connector and terminals for the vehicle side of the harness. (Highly recommended to update during installation.
_ Techflex Clean Cut protective sleeves on all tier 1 condition routing areas. with Tesa High-Performance Automotive Wiring Tape manufactured rated to resist temperatures from -40 F to 302 F. Abrasion Resistance Class D, Noise Damping (LV312) Class A.
What's in the Box?
Core Components:
_ X1 372108599 7. Front Frame Harness Fans/Horn/Fuel Pump/Sender (New Production)
_ X1 131SP10204 2. Bolt M6 Radiator Support Upper Stainless
_ X1 131SP10252 3. Washer M6 Stainless
_ X1 372108001 7.1 Frame Harness Mounting Pad W/ Insert/ Hardware
Electrical Components:
_ X1 Weather Pack Termination Kit (Fuel Pump/Sender Flying Leads) Compatible with all pump systems. Harness maintains factory color coding on wire legs.
_X1 Weather Pack Termination Kit (Cooling Fan System)
_X1 Termination Kit ( Brake Light Sensor on Master) NOTE- Must cars do not use this function. In order notes, ask to have it deleted if not required.
_X1 Termination Kit (Opposing side of 9 Pin factory connector located in washer bottle area) Required for warranty. DO NOT ATTEMPT TO PLUG AND PLAY to Existing harness end.
Factory Component History & Engineering Solutions:
The front frame harness is considered one of the most critical and unprotected harnesses in the DeLorean DMC-12s electrical system. As with the engine and ignition harnesses at the rear, the frame harness is given very little protection compared to the ever-changing environment it is exposed to. Constantly undergoing rigorous heat cycles from the cooling system dumping bled energy from the radiator/condenser stack up, this process takes a toll over time. Coupled with a direct line of contact with road debris and abrasion, it is a surprise that many are in working condition on driven cars. On the other hand, sitting is just as dangerous. Due to storage conditions, rodent damage and corrosion on connection points further degrades the harness's capacity to perform crucial tasks. The task of engineering a superior replacement required handling all critical elements listed above, including a revised routing path, abrasion-resistant harness covers, weather pack connectors, and extended flying lead sections at critical areas, including the notoriously short section branching to the pump and sender area.
1 Review Hide Reviews Show Reviews
-
Frame harness
Well constructed and gives me piece of mind when installed. Thanks DPI !